ID: 10
BU-49 FUME HOOD
₹81400.00
Fume exhaust hood are designed to contain and throw out toxic, obnoxious, pungent smelling gases to protect personnel and equipment in the laboratories. A motor driven dynamically balanced blower with minimum vibration and noise level, creates negative pressure and sucks contaminated air from work area and throws the same in high-up atmosphere through ducting. Fabricated out of thick ply-board clad from outside in laminated sheet and inside finished in non-corrosive, chemical resistant EPOXY paint. An up-down sliding sash made of teak wood mounted in thick glass is provided. Fluorescent lighting provided in the chamber. A gas tap and a power plug is also provided. Stainless steel wash basin and suitable water tap is also provided to hood at a suitable level from ground.
SEED TECHNOLOGY SEED GERMINATORS:
Suitable for conducting various experiments on the seed germination. Different environmental conditions can be created and controlled as per requirements. Double walled construction, inner made of thick mild steel sheet duly finished in stoving enamel paint. The gap is filled with glass wool to insulate loss of temperature.
Temperature range 5°C to 50°C ± 1°C controlled & indicated by a digital controller-cum-indicator. Humidity is created by heating water in a stainless steel chamber by an immersion heater ambient to 95% ± 3% RH and is controlled by a humidistat.
A full view inner clear acyclic door and double walled outer door with magnetic gaskets are provided Inner chamber has been provided with fluorescent illumination to create photo-simulation. An air- circulation fan has been provided to maintain uniform temperature in the whole chamber. For cooling a sealed compressor unit has been provided below the chamber to work independently. Supplied complete with 14 adjustable perforated trays, on-off switches, pilot lamps, other controls, cord & plug etc. the equipment is to work on 220V AC 50Hz single phase.
SEED TECHNOLOGY SEED GERMINATORS:
Suitable for conducting various experiments on the seed germination. Different environmental conditions can be created and controlled as per requirements. Double walled construction, inner made of thick mild steel sheet duly finished in stoving enamel paint. The gap is filled with glass wool to insulate loss of temperature.
Temperature range 5°C to 50°C ± 1°C controlled & indicated by a digital controller-cum-indicator. Humidity is created by heating water in a stainless steel chamber by an immersion heater ambient to 95% ± 3% RH and is controlled by a humidistat.
A full view inner clear acyclic door and double walled outer door with magnetic gaskets are provided Inner chamber has been provided with fluorescent illumination to create photo-simulation. An air- circulation fan has been provided to maintain uniform temperature in the whole chamber. For cooling a sealed compressor unit has been provided below the chamber to work independently. Supplied complete with 14 adjustable perforated trays, on-off switches, pilot lamps, other controls, cord & plug etc. the equipment is to work on 220V AC 50Hz single phase.
